Grundfos

UP 20-30 N 150
The pump unit is of the canned rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing. The bearings are lubricatd by the pumped liquid. The pump is characterized by:

The motor is a 1-phase motor. No additional motor protection is required.

Grundfos UP 20-30N Domestic Hot Water Service Pump Circulator, 230v.

The UP 20-30N is a Stainless Steel fixed-speed circulating pump suitable for domestic hot-water systems.

The UP 20-30N can be connected to an on/off time switch to save energy.

The on/off time switch can switch the pump on/off to limit pump operation to periods when hot water is usually required.

These pumps can be used in both open and closed systems.

Suitable for: Commercial heating, Domestic heating, Domestic hot water recirculation

This pump has now been replaced with the NEW UPS3 15-50/65 CLICK HERE

UNILIFT AP35B.50.08.A1V
Submersible effluent pump unit

Vertical single-stage Stainless Steel submersible pump with integrated submersible 1-phase motor.

The pump is equipped with ring stand and carrying handle and is supplied with a 10 m mains cable and a level switch for self-operating start and stop.

The impeller is a VORTEX impeller for 35 mm free passage appropriate for pumping surface water, groundwater, wastewater and similar.

The pump has a double shaft seal and an intermediate oil chamber pre-filled with non-toxic special oil.

The motor is insulation class F with thermal overload protection and has long-life deep-groove greased-for-life ball bearings.

The pump has Rp 2 inch discharge port and is ready for installation either free-standing or on an auto-coupling system.

Suitable for: Commercial wastewater, Domestic wastewater

UP 20-15 N 150
The pump unit is of the canned rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing. The bearings are lubricatd by the pumped liquid. The pump is characterized by:

The motor is a 1-phase motor. No additional motor protection is required.

Suitable for: Commercial heating, Domestic heating, Domestic hot water recirculation

UP 20-07 N 150
The pump unit is of the canned rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing. The bearings are lubricatd by the pumped liquid. The pump is characterized by:

The motor is a 1-phase motor. No additional motor protection is required.

Suitable for: Commercial heating, Domestic heating, Domestic hot water recirculation

UNILIFT AP35B.50.08.1V
Submersible effluent pump unit

Vertical single-stage Stainless Steel submersible pump with integrated submersible 1-phase motor.

The pump is equipped with ring stand and carrying handle and is supplied with a 10 m mains cable.

The impeller is a VORTEX impeller for 35 mm free passage appropriate for pumping surface water, groundwater, wastewater and similar.

The pump has a double shaft seal and an intermediate oil chamber pre-filled with non-toxic special oil.

The motor is insulation class F with thermal overload protection and has long-life deep-groove greased-for-life ball bearings.

The pump has Rp 2 inch discharge port and is ready for installation either free-standing or on an auto-coupling assembly.

Suitable for: Commercial wastewater, Domestic wastewater

COMFORT 15-14 B

COMFORT is an high-efficiency circulator designed for hot-water recirculation in residential buildings with a dedicated return line. It is compatible with all types of water heater tanks, tankless systems, solar or heat pumps whether or not the system has mixing or tampering valves installed.

The pump features a space-efficient housing and a permanent magnet with an integrated control unit. The spherical rotor, equipped with an impeller, ensures optimal functionality supported by a heavy-duty single-bearing ball system. The drinking-water approved brass pump housing guarantees both safety and reliability.

COMFORT features the continuous operation 24/7 mode which is appropriate for external control via plug-in timer, gas boiler or heat-pump controller.

The product features:

Suitable for: Domestic hot water recirculation

The Grundfos Unilift KP 150-A-1 drainage pump is engineered to deliver reliable performance across a wide range of dewatering and water transfer applications. It is well suited to sump and cellar drainage, emptying tanks and swimming pools, and handling general domestic and light commercial duties where dependable operation is essential.

Built to a high specification, the pump incorporates durable Stainless Steel components to support long service life and consistent performance. Single-phase versions are equipped with an integrated automatic thermal overload protection device, safeguarding the motor against overheating in the event of dry running.

The wet rotor configuration allows the unit to tolerate short periods of dry operation without damage. An open impeller design featuring sling and bevelled-edge vanes helps minimise the risk of blockage by fibres and debris, ensuring smooth and efficient pumping in demanding conditions.

The Grundfos Unilift KP 150-AV1 drainage pump is engineered to deliver reliable performance across a wide range of dewatering and water transfer applications. It is well suited to sump and cellar drainage, emptying tanks and swimming pools, and handling general domestic and light commercial duties where dependable operation is essential.

Built to a high specification, the pump incorporates durable Stainless Steel components to support long service life and consistent performance. Single-phase versions are equipped with an integrated automatic thermal overload protection device, safeguarding the motor against overheating in the event of dry running.

The wet rotor configuration allows the unit to tolerate short periods of dry operation without damage. An open impeller design featuring sling and bevelled-edge vanes helps minimise the risk of blockage by fibres and debris, ensuring smooth and efficient pumping in demanding conditions.

The Grundfos Unilift KP 250-M1 drainage pump is engineered to deliver reliable performance across a wide range of dewatering and water transfer applications. It is well suited to sump and cellar drainage, emptying tanks and swimming pools, and handling general domestic and light commercial duties where dependable operation is essential.

Built to a high specification, the pump incorporates durable Stainless Steel components to support long service life and consistent performance. Single-phase versions are equipped with an integrated automatic thermal overload protection device, safeguarding the motor against overheating in the event of dry running.

The wet rotor configuration allows the unit to tolerate short periods of dry operation without damage. An open impeller design featuring sling and bevelled-edge vanes helps minimise the risk of blockage by fibres and debris, ensuring smooth and efficient pumping in demanding conditions.

Unilift CC5 - M1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for manual operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

Unilift CC5 - A1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for self-operating operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

Unilift CC7 - M1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for manual operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

Unilift CC7 - A1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for self-operating operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

Unilift CC9 - M1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for manual operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

SOLOLIFT2 WC-1

Sololift2 WC-1 is a small, space-efficient self-operating lifting station appropriate for pumping of wastewater in private dwellings in places where wastewater cannot be led directly to the sewer by means of a natural downward slope.

Sololift2 WC-1 is appropriate for pumping wastewater from a toilet containing toilet paper and faeces with an additional connection on the lid for, for example, a washbasin.

The pumping of liquids containing other material may cause faults and limit the scope of our guarantee.

Sololift2 WC-1 is typically used to dewater:

The space-efficient lifting station is equipped with:

Design according to EN12050-3 and production inspection by external institute with unique features focused on quick installation, long-lasting operation and straightforward-clean service.

Suitable for: Domestic wastewater