Stuart Turner

Submersible Unit Engineered to pump solids up to 5 mm and can be used in either automatic or manual modes. Complete with integral float switch, the Supersub 150VA is ideal for the transference of non foul water and suitable for both clean and grey water. The pump is compact in design and easy to install.

Universal Twin Monsoon Universal 3.0 Bar. Twin Shower Unit. Intended for setup into vented systems to pump both the hot and cold water supplies boosting both equally. Suitable for both positive and negative head applications.

Universal Single Monsoon Universal 3.0 Bar. Single Unit. Can be used in pairs to boost vented setups to pump hot and cold water supplies independently, or as a single pump to boost a water supply as required. Suitable for both positive and negative head applications.

Typical Single Unit MONSOON Typical 3.0 bar Single Unit. Can be used in pairs to pump hot and cold water supplies independently, or as a single pump to boost the hot or cold water supply as required. High quality, high performance compact pump supplied with two 15 mm anti-vibration flexible hoses.

Typical Twin Unit Monsoon Typical 3.0 Bar. Twin Shower Unit. Designed for installation into vented systems to pump both hot & cold water supplies, boosting both equally to an individual shower, complete bathroom, or whole house. Suitable for positive head applications only.

Centrifugal Horizontal Unit Single Stage Intended to provide a pressurised liquid supply from a break tank in either a positive or negative head application, as it does not rely on gravity flow to activate. The CH 12-14 B is suitable for commercial or domestic use, pumping hot or cold water and supplied with G1 flexible hoses.

Typical Twin Unit Monsoon Typical 1.5 Bar. Twin Shower Unit. Designed for installation into vented systems to pump both hot & cold water supplies, boosting both equally to an individual shower, complete bathroom, or whole house. Suitable for positive head applications only.

Mains Boost Unit Product Discontinued - replaced by the new STORMBOOST Appropriate for reduced occupancy properties with typically one bathroom. The FLOMATE MBF-12 Pump is designed to be connected directly to the incoming mains and will deliver an additional 1.5 Bar. pressure to the existing mains pressure and a maximum flow rate of 12 litres per minute. The pump will start automatically when a flow rate of 0.6 litres per minute or more exists.

The STORMBOOST 60 is the new upgraded and enhanced direct replacement for the original Flomate MBF60._x000D_ _x000D_ STORMBOOST 60 is designed to be connected directly to the incoming cold water mains and activate automatically when a tap is opened or a shower is switched on, boosting mains water pressure and flow throughout the property._x000D_ _x000D_ It will deliver up to 16 litres/min flow at up to 3.2 Bar.

Mains Boost Setup Product Discontinued - replaced by the new STORMBOOST 100 FLOMATE MBF-100 is appropriate for household properties with one bathroom. Designed to sit within a typical kitchen 600 mm larder style cupboard it will deliver up to 18 litres/minute flow at 3.2 Bar.

Designed to sit within a typical kitchen 600 mm wide larder style cupboard or other home applications. It will deliver up to 22 litres/min flow at up to 3.2 Bar. pressure for up to 11 minutes after which time it will deliver up to 12 litres/minute continuously until demand ends and the pressure vessel recharges*. _x000D_ _x000D_ * The actual flow rate may less less than this and is dependent on the mains supply flow available.

Mains Boost Setup Product Discontinued - replaced by the new STORMBOOST 300 FLOMATE MBF-300 is appropriate for household applications with one or two bathrooms. Designed to sit within a typical kitchen 600 mm larder style cupboard it will deliver up to 24 litres/minute flow at 3.2 Bar.

Centrifugal Horizontal Unit multi-stage The STUART CH4-40 centrifugal multi-stage pump is optimal for pressure boosting in applications where long pipe runs or high heads may be involved. CH 4-40 pumps are self priming up to 5 metres and offer a high quality, reliable solution with flow rates up to 160 litres per minute and heads up to 36 metres.

Centrifugal Horizontal Unit multi-stage STUART CH4-40 FL pumps are optimal for water pressurisation to outlets in a positive head application, where an instant boosted supply is required from a simple to install package. CH Automatic Flow Switch pumps require a gravity flow of 1 litre/minute to operate and are suitable for commercial or domestic use, pumping hot or cold water at flow rates up to 141 litres per minute and heads up to 36 metres.

Unit Management Module The Management Module remotely switches pumps without controls and can be used in both positive and negative head plumbing systems. The pump incorporates a pressure switch to start a connected pump and a flow switch to stop the pump, ensuring a continuous supply of boosted water to all outlets without hunting. Incorporating pump run dry protection, the control module features a simple LED display for power on, pump running and fault indication.

The Stuart Turner SPU 130 Mini Pressurisation Unit is perfect for domestic use. _x000D_ Quick and simple installation. Housed in a compact and robust housing for easy wall mounting. _x000D_ Comes with category 5 backflow protection, Type AB air gap , weir overflow and warning pipe.