Stuart Turner

Universal Twin

Monsoon Universal 3.0 bar. Twin Shower Unit. Intended for setup into vented systems to pump both the hot and cold water supplies boosting both equally. Suitable for both positive and negative head applications.

Universal Single

Monsoon Universal 3.0 bar. Single Unit. can be utilised in pairs to boost vented setups to pump hot and cold water supplies independently, or as a single pump to boost a water supply as required. Suitable for both positive and negative head applications.

Typical Single Unit

MONSOON Typical 3.0 bar Single Unit. can be utilised in pairs to pump hot and cold water supplies independently, or as a single pump to boost the hot or cold water supply as required.
High quality, high performance compact pump supplied with two 15 mm anti-vibration flexible hoses.
All MONSOON Standard pumps are suitable for use in open vented (gravity fed) systems for positive head applications where the existing flow due to gravity is more than 1 litre/min.

Applications

• Boosting hot or cold water supplies to a single tap or the blended water between a shower valve and shower head in low pressure gravity systems
• MONSOON Standard pumps are suitable for use where there is already more than 1 litre/min flow from the outlet(s) to be boosted

Typical Twin Unit

Monsoon Typical 3.0 bar. Twin Shower Unit. Designed for installation into vented systems to pump both hot & cold water supplies, boosting both equally to an individual shower, complete bathroom, or whole house. Suitable for positive head applications only.

Universal Twin

Monsoon Universal 4.5 bar. Twin Shower Unit. Intended for setup into vented systems to pump both the hot and cold water supplies boosting both equally. Suitable for both positive and negative head applications.

Universal Single

Monsoon Universal 4.5 bar. Single Shower Unit. can be utilised in pairs to boost vented setups to pump hot and cold water supplies independently, or as a single pump to boost a water supply as required. Suitable for both positive and negative head applications.

Typical Twin Unit

Monsoon Typical 4.5 bar. Twin Shower Unit. Designed for installation into vented systems to pump both hot & cold water supplies, boosting both equally to an individual shower, complete bathroom, or whole house. Suitable for positive head applications only.

Typical Single Unit

MONSOON Typical 4.5 bar Single Unit. can be utilised in pairs to pump hot and cold water supplies independently, or as a single pump to boost the hot or cold water supply as required.
High quality, high performance compact pump supplied with two 15 mm anti-vibration flexible hoses.
All MONSOON Standard pumps are suitable for use in open vented (gravity fed) systems for positive head applications where the existing flow due to gravity is more than 1 litre/min.

Applications

• Boosting hot or cold water supplies to a single tap or the blended water between a shower valve and shower head in low pressure gravity systems
• MONSOON Standard pumps are suitable for use where there is already more than 1 litre/min flow from the outlet(s) to be boosted

Mains Boost Unit

Product Discontinued - replaced by the new STORMBOOST

Appropriate for reduced occupancy properties with typically one bathroom.
The FLOMATE MBF-12 Pump is designed to be connected directly to the incoming mains and will deliver an additional 1.5 bar. pressure to the existing mains pressure and a maximum flow rate of 12 litres per minute.
The pump will start automatically when a flow rate of 0.6 litres per minute or more exists.

The STORMBOOST 60 is the new upgraded and enhanced direct replacement for the original Flomate MBF60.
STORMBOOST 60 is designed to be connected directly to the incoming cold water mains and activate automatically when a tap is opened or a shower is switched on, boosting mains water pressure and flow throughout the property.

It will deliver up to 16 litres/min flow at up to 3.2 bar. pressure for up to 8 minutes after which time it will deliver up to 12 litres/minute continuously until demand ends and the pressure vessel recharges*.

* The actual flow rate may less less than this and is dependent on the mains supply flow available.

APPLICATIONS

• Boosting mains water pressure to one bathroom properties fitted with a combi-boiler
• STORMBOOST 60 fits neatly within a standard kitchen base pump
• Boosts mains water pressure up to 3.2 bar.
• Output flow rate up to 16 litres/minute for up to 8 minutes
• 60 litre nominal capacity pressure vessel
• Switches on/off automatically
• Quiet operation
• High quality, robust brass pump body and impeller
• High reliability induction motor
• Integral bypass
• Anti-seize exercise function
• Dry run protection
• Anti-vibration connection hoses included
• WRAS Approved Product
• 3 year warranty
   
   
   
   
   
   
   
   
   
   
   
   
   

Mains Boost Setup

Product Discontinued - replaced by the new STORMBOOST 80

FLOMATE MBF-80 can be connected directly to the incoming mains and will deliver up to 16 litres/minute throughput at 3.2 bar. pressurisation to multiple outlets within the property, up to the preset cut-in limit of the 60 litre pressure vessel, at which time the system will deliver 12 litres/minute until demand ends and the pressure vessel recharges.

Designed for low occupancy properties with one bathroom and fits neatly within a standard 500 mm kitchen base pump.

Designed to sit within a typical kitchen 600 mm wide larder style cupboard or other home applications. It will deliver up to 22 litres/min flow at up to 3.2 bar. pressure for up to 11 minutes after which time it will deliver up to 12 litres/minute continuously until demand ends and the pressure vessel recharges*.

* The actual flow rate may less less than this and is dependent on the mains supply flow available.