Stuart Turner

Suitable for maintaining pressure in large domestic and commercial sealed heating systems, chilled water systems, refrigeration pumps and industrial cooling systems. Stuart SPU Maxi pumps are exceptionally easy to install and commission and are housed in a compact and robust enclosure suitable for floor mounting.

Suitable for maintaining pressure in large domestic and commercial sealed heating systems, chilled water systems, refrigeration pumps and industrial cooling systems. Stuart SPU Maxi pumps are exceptionally easy to install and commission and are housed in a compact and robust enclosure suitable for floor mounting.

Unvented Cylinder - Indirect

The Aquastor Sigma range of unvented indirect hot liquid cylinders are optimal for elevated demand applications and offer an all Stainless Steel construction to the highest standards, with a maximum operating pressure of 4.5 bar..
The Sigma range has been designed with higher demand flow rates in mind and features 1 " BSP connections.
Available in a range of cylinder sizes with an ErP B classification.
1 " hot and cold water connections
½" temperature and pressure relief valve
4.5 bar. maximum operating pressure
3 KW immersion heater
22 mm high performance heating coil

Unvented Cylinder - Tank-in-Tank

The Aquastor Amega range of unvented indirect hot liquid cylinders use tank in tank technology which leads to rapid heat recovery for greater operation. These cylinders are capable of heating large quantities of water within a very short time, making them ideal for large commercial and industrial applications where a large volume of hot water is required and where demand can peak at different times.

SAA240
1" BSP primary connection
¾" BSP cold feed/hot draw off

The Stuart Turner range of dosing pots are engineered to insert liquid chemicals, usually corrosion inhibitor or anti-freeze solutions, into closed heating or chilled water systems.

For concentration levels of themes chemicals please always consult the specific manufacturer's recommendations.

Stuart Turner Dosing Pots are suppoed as a kit of components which will need to be assembled as per the Configuration section of the Technical Documentation.

The dosing pot kit consists of:

• Fabricated vessel with welded construction
• 2 x wall brackets (integral with vessel)
• Manual air vent valve
• Tundish
• 4 x isolation valves
• 4 x pipe nipples
• 2 x tee piece

Features & Benefits:

• AISI 304 Stainless Steel fabricated vessel with welded construction and tundish
• 10 bar. maximum working pressure
• 90 degree C maximum operating temperature
• 2 x wall brackets integral vessel
• All pipe connections are 1" BSP
• Simple and safe to operate and flush clean
• All connections to the system can be isolated by the ball valves
• All dosingpots comply with the pressure equipment directive (PED) 2014/68/EU