Stuart Turner

Mains Boost Setup Product Discontinued - replaced by the new STORMBOOST 300 FLOMATE MBF-300 is appropriate for household applications with one or two bathrooms. Designed to sit within a typical kitchen 600 mm larder style cupboard it will deliver up to 24 litres/minute flow at 3.2 Bar.

Mains Liquid Boosting Setup The MAINSBOOST MB 300SV-1 is intended for 'direct on mains' systems (unvented hot water cylinders and combination boilers) where the incoming mains pressure is greater than 2.5 Bar. but the flow is insufficient to meet demand. MAINSBOOST vessel systems do not require an electrical supply and operate silently. System cold water storage capacity can be expanded simply by adding one or more MAINSBOOST Add-on pumps as required.

The 2 vessel Mainsboost 300 litre vertical steel system with 22 mm connections are installed directly onto the incoming water supply and under mains pressure fills with water. When the chamber is full the pump reaches a state of pressure equilibrium. The Mainsboost system now has a volume of pressurised water ready for distribution throughout the property.

The 3 vessel Mainsboost 300 litre vertical steel system with 22 mm connections are installed directly onto the incoming water supply and under mains pressure fills with water. When the chamber is full the pump reaches a state of pressure equilibrium. The Mainsboost system now has a volume of pressurised water ready for distribution throughout the property.

Designed to sit within a typical kitchen 600 mm wide larder style cupboard or other home applications. It will deliver up to 27 litres/min flow at up to 3.2 Bar. pressure for up to 11 minutes after which time it will deliver up to 12 litres/minute continuously until demand ends and the pressure vessel recharges*. _x000D_ _x000D_ * The actual flow rate may less less than this and is dependent on the mains supply flow available.