Stuart Turner

Unvented Cylinder - Tank-in-Tank

The Aquastor Amega range of unvented indirect hot liquid cylinders use tank in tank technology which leads to rapid heat recovery for greater operation. These cylinders are capable of heating large quantities of water within a very short time, making them ideal for large commercial and industrial applications where a large volume of hot water is required and where demand can peak at different times.

SAA420
1½" BSP primary connection
1½" BSP cold feed/hot draw off

The STORMBOOST 80 is the new upgraded and enhanced direct replacement for the original Flomate MBF-80.

STORMBOOST 80 is designed to be connected directly to the incoming cold water mains and activate automatically when a tap is opened or a shower is switched on, boosting mains water pressure and flow throughout the property.

It will deliver up to 16 litres/min flow at up to 3.2 bar. pressure for up to 11 minutes after which time it will deliver up to 12 litres/minute continuously until demand ends and the pressure vessel recharges*.

* The actual flow rate may less less than this and is dependent on the mains supply flow available.

APPLICATIONS

• Boosting mains water pressure to one or two bathroom properties fitted with a combi-boiler
• STORMBOOST 80 fits neatly within a standard kitchen base pump

Suitable for higher occupancy properties with two bathrooms or more, the 80 requires no on-site commissioning and fits neatly within a standard kitchen base pump.

• Boosts mains water pressure up to 3.2 bar.
• Output flow rate up to 16 litres/minute for up to 11 minutes
• 80 litre nominal capacity pressure vessel
• Switches on/off automatically
• Quiet operation
• High quality, robust brass pump body and impeller
• High reliability induction motor
• Integral bypass
• Anti-seize exercise function
• Dry run protection
• Anti-vibration connection hoses included
• WRAS Approved Product
• 3 year manufacturer warranty