Stuart Turner

Mains Boost Setup

Product Discontinued - replaced by the new STORMBOOST 300

FLOMATE MBF-300 is appropriate for household applications with one or two bathrooms.

Designed to sit within a typical kitchen 600 mm larder style cupboard it will deliver up to 24 litres/minute flow at 3.2 bar. pressure, dependant on the chosen pressure vessel variant, to multiple outlets within the property, up to the preset cut-in limit at which time the system will deliver 12 litres/minute until demand ends and the pressure vessel recharges.

Replacement reed switch suitable for all Monsoon Standard and Monsoon Universal pumps manufactured after 2008.

Contents:

• Reed Switch x1
• Strain Relief Bush x1
• Tie Wrap x1
• Screw Self Tapping 3.5mmx12mm x4
• Screw Self Tapping K40x16mm x4

Stuart Turner (est. 1906) is a UK manufacturer of water boosting and pressurisation systems. Their ranges include shower pumps, whole-house boosting sets and mains-pressure solutions. Typical applications are improving water pressure and flow in homes and light commercial buildings.

Spare Part

Replacement pressurisation vessel, appropriate for all Monsoon Universal pumps manufactured after 2008.

Contents:

• Pressure Vessel 0.6 Litre (x1)
• Rubber Washer 1/2" BSP (x1)
• O-Ring (x1)

Unit Management Module

The Management Module remotely switches pumps without controls and can be utilised in both positive and negative head plumbing systems.
The pump incorporates a pressure switch to start a connected pump and a flow switch to stop the pump, ensuring a continuous supply of boosted water to all outlets without hunting. Incorporating pump run dry protection, the control module features a simple LED display for power on, pump running and fault indication.
The pump is supplied with a 70 mm long extension piece allowing the module to clear the pump terminal box.

Submersible Unit

The Supervort 140A submersible pump is intended for the transference of dirty water and is capable of handling semi-solids in suspension of up to 20 mm diameter.
This pump is compact in design, easy to install and features an external adjustable float switch.

Submersible Unit

The Supervort 240A submersible pump is intended for the transference of dirty water and is capable of handling semi-solids in suspension of up to 20 mm diameter.
This pump is compact in design, easy to install and features an external adjustable float switch.

Support Kit

This comprehensive Support Kit is appropriate for all Monsoon Universal pumps manufactured after 2008.

If your pump is older than this please contact TechAssist on +44 (0) 800 31 969 80.

Contents:

• Printed Circuit Board (x1)
• Motor Capacitor 5uF (x1)
• Motor Capacitor 7uF (x1)
• Motor Capacitor 10uF (x1)
• Motor Capacitor 12uF (x1)
• Inlet Strainer (x2)
• Rotary Seal Assembly (x2)
• Seal Counterface (x2)
• Seal Applicator Tool (x1)
• Pressure Vessel (x1)
• Pressure Switch 1 bar. (x1)
• Pressure Switch 1.5 bar. (x1)
• Magnetic Float Assembly (x2)
• Reed Switch (x2)
• Reed Switch Tie Wrap (x2)
• O-Ring ID 66.4 mm x 1.78 mm section (x2)
• Woodruff Key (x2)
• Circlip (x2)
• Stainless Steel Washer (x2)
• Screw Pozi Drive M6 x 35 (x8)
• Screw M4 x 16 (x8)
• Screw 3.5 x 12 mm (x4)

Jet Unit

Optimal for the elevated pressure delivery of clean non-potable water from a water tank/cistern, such as water pressurisation and lawn sprinklers. Jet pumps will self prime up to 5 metres and are supplied with a carry handle, a manual on/off switch and power lead fitted with a 13 Amp fused plug. The range is suitable for general purpose use, pumping cold water.

Jet Unit

Optimal for the elevated pressure delivery of clean non-potable water from a water tank/cistern in either a positive or negative head application. Jet Boostamatic pumps provide fully automatic pressure/flow switch control, will self prime up to 5 metres and are supplied with a power lead fitted with a 13 Amp fused plug.
The range is suitable for general purpose use, pumping cold water.