MAGNA1 D 32-80 F

The Grundfos MAGNA1 is a circulator pump unit with permanent magnet motor and straightforward selection of pump setting. The MAGNA1 will fit both heating, cooling and domestic hot water circulation applications perfectly, making it the obvious choice for almost any building project – old or new.

The pump is a canned-rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing.

The bearings are lubricated by the pumped liquid. A pump with no maintenance requirements and extremely low life cycle cost.

The pump has an intuitive user interface, which is especially fit for replacement of older circulators. The well-suited choice for basic performance needs in applications where system communication is not required.

Suitable for: Commercial heating, Commercial air conditioning, District heating, District cooling, Domestic heating, Industrial heating

The PH2D pressurisation unit is a simple, robust and reliable mechanical pressurisation unit that has been designed with over 60 years of experience is highly engineered system equipment. Throughout a heating system, there is always potential for slight leaks to occur which gradually decrease system pressure leading to inefficient or disabled heating.

The Jabsco Pumpguard Fresh Water Inlet Pump With Strainer - Threaded - 120mm. This product is manufactured by Jabsco. This is a Surface Mounted pump which can be suitable when the pump can sit in a dry, accessible location and draw liquid in via a suction pipe or hose.

The Jabsco Self Priming Fuel Transfer Pump - Diesel - 50 Ltr/min. - 12v - Obsolete is a Fuel Transfer Pump item. This product is manufactured by Jabsco. Voltage for this item is 12V. It has an actual flow rate of 50 Ltr/min. This is a Surface Mounted pump which can be suitable when the pump can sit in a dry, accessible location and draw liquid in via a suction pipe or hose.

Unilift CC7 - A1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for self-operating operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

Single phase, 0.5kW, WRAS approved horizontal multistage pump with 3 impellers and a 1" threaded discharge port.
The Lowara 3HM06S05M5HVBE is a single phase horizontal multistage pump with a 0.5KW motor. This product is manufactured by Lowara. The e-HM range are high efficiency horizontal multistage pumps frequently applied in water supply and pressure boosting, particularly in larger residential installations. They are manufactured from high quality Stainless Steel components to ensure a long service life and excellent reliability. Lowara use these pumps in their own range of booster sets, as do some other manufacturers. They are available with the Teknospeed variable speed drive for constant pressure control, as well as the simpler Genyo controller, pressure switch on/off controller or just as a simple pump.

The Lowara 1HM04P05M5HVBE Horizontal Multistage Pump - 240v - Single Phase is a Multistage pump. Voltage for this item is 240V.

Order the Biral A 12-1 from Pumpify and receive free standard delivery.

The Biral A 12-1 Circulator Pump - 230v is a Circulator Pump item. Voltage for this item is 230V. The maximum head for this pump is 4m. This is a Surface Mounted pump which can be suitable when the pump can sit in a dry, accessible location and draw liquid in via a suction pipe or hose.

The operating pressure of this is 10 bar.