D70L is a WEDA D range submersible drainage pump for clean and dirty water. Manual 400V Three Phase 1000 Ltr/min 33m Head. Designed for dewatering duties across construction and industrial sites.

D60H is a WEDA D range submersible drainage pump for clean and dirty water. Manual 400V Three Phase 283 Ltr/min 51m Head. Designed for dewatering duties across construction and industrial sites.

D40N is a WEDA D range submersible drainage pump for clean and dirty water. Manual 400V Three Phase 375 Ltr/min 21m Head. Designed for dewatering duties across construction and industrial sites.

D30N is a WEDA D range submersible drainage pump for clean and dirty water. Manual 400V Three Phase 158 Ltr/min 25m Head. Designed for dewatering duties across construction and industrial sites.

D30N is a WEDA D range submersible drainage pump for clean and dirty water. Manual 230V Single Phase 158 Ltr/min 25m Head. Designed for dewatering duties across construction and industrial sites.

D30L is a WEDA D range submersible drainage pump for clean and dirty water. Manual 400V Three Phase 308 Ltr/min 17m Head. Designed for dewatering duties across construction and industrial sites.

D10N is a WEDA D range submersible drainage pump for clean and dirty water. Manual 230V Single Phase 99 Ltr/min 15m Head. Designed for dewatering duties across construction and industrial sites.

D10N is a WEDA D range submersible drainage pump for clean and dirty water. 110V Single Phase 99 Ltr/min 15m Head. Designed for dewatering duties across construction and industrial sites.

D60SH is a WEDA D range submersible drainage pump for clean and dirty water. 400V Three Phase 1050 Ltr/min 59m Head. Designed for dewatering duties across construction and industrial sites.

MAGNA1 D 32-80 F

The Grundfos MAGNA1 is a circulator pump unit with permanent magnet motor and straightforward selection of pump setting. The MAGNA1 will fit both heating, cooling and domestic hot water circulation applications perfectly, making it the obvious choice for almost any building project – old or new.

The pump is a canned-rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing.

The bearings are lubricated by the pumped liquid. A pump with no maintenance requirements and extremely low life cycle cost.

The pump has an intuitive user interface, which is especially fit for replacement of older circulators. The well-suited choice for basic performance needs in applications where system communication is not required.

Suitable for: Commercial heating, Commercial air conditioning, District heating, District cooling, Domestic heating, Industrial heating