D30N is a WEDA D range submersible drainage pump for clean and dirty water. Automatic 230V Single Phase 158 Ltr/min 25m Head. Designed for dewatering duties across construction and industrial sites.

D30N is a WEDA D range submersible drainage pump for clean and dirty water. Manual 230V Single Phase 158 Ltr/min 25m Head. Designed for dewatering duties across construction and industrial sites.

D30L is a WEDA D range submersible drainage pump for clean and dirty water. Automatic 230V Single Phase 308 Ltr/min 17m Head. Designed for dewatering duties across construction and industrial sites.

D10N is a WEDA D range submersible drainage pump for clean and dirty water. 230V Single Phase 99 Ltr/min 15m Head. Designed for dewatering duties across construction and industrial sites.

D10N is a WEDA D range submersible drainage pump for clean and dirty water. Manual 230V Single Phase 99 Ltr/min 15m Head. Designed for dewatering duties across construction and industrial sites.

D08N is a WEDA D range submersible drainage pump for clean and dirty water. 230V Single Phase 58 Ltr/min 44m Head. Designed for dewatering duties across construction and industrial sites.

D04N is a WEDA D range submersible drainage pump for clean and dirty water. 230V Single Phase 227 Ltr/min 11m Head. Designed for dewatering duties across construction and industrial sites.

D04BN is a WEDA D range submersible drainage pump for clean and dirty water. 230V Single Phase 158 Ltr/min 11m Head. Designed for dewatering duties across construction and industrial sites.

MAGNA1 D 50-120 F

The Grundfos MAGNA1 is a circulator pump with permanent magnet motor and easy selection of pump setting. The MAGNA1 will fit both heating, cooling and domestic hot water circulation applications perfectly, making it the obvious choice for almost any building project – old or new.

The pump is a canned-rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing.

The bearings are lubricated by the pumped liquid. A pump with no maintece requirements and extremely low life cycle cost.

The pump has an intuitive user interface, which is especially fit for replacement of older circulators. The ideal choice for basic performance needs in applications where system communication is not required.

MAGNA1 D 32-80 F

The Grundfos MAGNA1 is a circulator pump unit with permanent magnet motor and straightforward selection of pump setting. The MAGNA1 will fit both heating, cooling and domestic hot water circulation applications perfectly, making it the obvious choice for almost any building project – old or new.

The pump is a canned-rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing.

The bearings are lubricated by the pumped liquid. A pump with no maintenance requirements and extremely low life cycle cost.

The pump has an intuitive user interface, which is especially fit for replacement of older circulators. The well-suited choice for basic performance needs in applications where system communication is not required.

Suitable for: Commercial heating, Commercial air conditioning, District heating, District cooling, Domestic heating, Industrial heating

The PH2D pressurisation unit is a simple, robust and reliable mechanical pressurisation unit that has been designed with over 60 years of experience is highly engineered system equipment. Throughout a heating system, there is always potential for slight leaks to occur which gradually decrease system pressure leading to inefficient or disabled heating.

Spare motor for high-efficiency pumps Wilo-Yonos MAXO/-D in the event of replacement.

Complete functional unit with drive motor, impeller and electronics module.

The functional equipment is equivalent to that of the pump.

Scope of delivery

Wilo - spare motor, Accessories kit (O-ring, 4 motor fastening screws), and Installation manual and operating instructions.

Jabsco Motor Self Priming Pump Unit - 230v - Single Phase - BRZ MPU

The Jabsco Motor Self Priming Pump Unit - 230v - Single Phase - BRZ MPU is a Self-Priming item. This product is manufactured by Jabsco. Voltage for this item is 230V. It has an actual flow rate of 4.5 Ltr/min. This is a Surface Mounted pump which can be suitable when the pump can sit in a dry, accessible location and draw liquid in via a suction pipe or hose.

The operating pressure of this is 2 bar.

Unilift CC7 - A1

Grundfos Unilift CC pumps are single-stage submersible pumps with a low suction ability down to 3 mm water level. The pumps are designed for pumping rainwater and grey wastewater, e.g. from

The pumps are appropriate for both stationary and portable use. They are for self-operating operation. The pumps allow free passage of particles up to ¸10 mm.

The motor incorporates self-operating overload protection cutting out the motor in case of overload. When cooled to normal temperature, the motor restarts automatically.

Suitable for: Commercial wastewater, Domestic wastewater, Industrial wastewater treatment and reuse

Order the Biral A 12-1 from Pumpify and receive free standard delivery.

The Biral A 12-1 Circulator Pump - 230v is a Circulator Pump item. Voltage for this item is 230V. The maximum head for this pump is 4m. This is a Surface Mounted pump which can be suitable when the pump can sit in a dry, accessible location and draw liquid in via a suction pipe or hose.

The operating pressure of this is 10 bar.