Stuart Turner

Peripheral Horizontal Unit

Intended for ongoing use, the Stainless Steel peripheral range is ideal for handling non abrasive liquids and is developed specifically for beer, lager or cider dispensing.
Also used for pumping demineralised water.

Peripheral Horizontal Unit

Intended for ongoing use, the Stainless Steel peripheral range is ideal for handling non abrasive liquids and is developed specifically for beer, lager or cider dispensing.
Also used for pumping demineralised water.

Mains Boost Unit

Product Discontinued - replaced by the new STORMBOOST

Appropriate for reduced occupancy properties with typically one bathroom.
The FLOMATE MBF-12 Pump is designed to be connected directly to the incoming mains and will deliver an additional 1.5 bar. pressure to the existing mains pressure and a maximum flow rate of 12 litres per minute.
The pump will start automatically when a flow rate of 0.6 litres per minute or more exists.

The STORMBOOST 60 is the new upgraded and enhanced direct replacement for the original Flomate MBF60.
STORMBOOST 60 is designed to be connected directly to the incoming cold water mains and activate automatically when a tap is opened or a shower is switched on, boosting mains water pressure and flow throughout the property.

It will deliver up to 16 litres/min flow at up to 3.2 bar. pressure for up to 8 minutes after which time it will deliver up to 12 litres/minute continuously until demand ends and the pressure vessel recharges*.

* The actual flow rate may less less than this and is dependent on the mains supply flow available.

APPLICATIONS

• Boosting mains water pressure to one bathroom properties fitted with a combi-boiler
• STORMBOOST 60 fits neatly within a standard kitchen base pump
• Boosts mains water pressure up to 3.2 bar.
• Output flow rate up to 16 litres/minute for up to 8 minutes
• 60 litre nominal capacity pressure vessel
• Switches on/off automatically
• Quiet operation
• High quality, robust brass pump body and impeller
• High reliability induction motor
• Integral bypass
• Anti-seize exercise function
• Dry run protection
• Anti-vibration connection hoses included
• WRAS Approved Product
• 3 year warranty
   
   
   
   
   
   
   
   
   
   
   
   
   

Centrifugal Horizontal Unit multi-stage

Intended to provide a pressurised liquid supply from a break tank in either a positive or negative head application. STUART CH4-50 B multi-stage Boostamatic pumps are self priming up to 5 metres and do not rely on a gravity flow of water to activate. With flow rates up to 135 litres/minute and heads up to 51 metres, these pumps are suitable for commercial or domestic use, pumping hot or cold water and are supplied with G1 flexible hoses and adaptors.

Centrifugal Horizontal Unit multi-stage

The STUART CH4-30 centrifugal multi-stage pump is optimal for pressure boosting in applications where long pipe runs or high heads may be involved. CH 4-30 pumps are self priming up to 5 metres and offer a high quality, reliable solution with flow rates up to 140 litres per minute and heads up to 25 metres.

Centrifugal Horizontal Unit multi-stage

The STUART CH4-40 centrifugal multi-stage pump is optimal for pressure boosting in applications where long pipe runs or high heads may be involved. CH 4-40 pumps are self priming up to 5 metres and offer a high quality, reliable solution with flow rates up to 160 litres per minute and heads up to 36 metres.

Centrifugal Horizontal Unit multi-stage

The STUART CH4-50 centrifugal multi-stage pump is optimal for pressure boosting in applications where long pipe runs or high heads may be involved. CH 4-50 pumps are self priming up to 5 metres and offer a high quality, reliable solution with flow rates up to 160 litres per minute and heads up to 50 metres.

Centrifugal Horizontal Unit multi-stage

The CH 4-60 centrifugal multi-stage pump is optimal for pressure boosting in applications where long pipe runs or high heads may be involved. CH 4-60 pumps are self priming up to 5 metres and offer a high quality, reliable solution with flow rates up to 160 litres per minute and heads up to 62 metres.

Centrifugal Horizontal Unit multi-stage

STUART CH 4-30 FL pumps are optimal for water pressurisation to outlets in a positive head application, where an instant boosted supply is required from a simple to install package. CH Automatic Flow Switch pumps require a gravity flow of 1 litre/minute to operate and are suitable for commercial or domestic use, pumping hot or cold water at flow rates up to 134 litres per minute and heads up to 25 metres.

Centrifugal Horizontal Unit multi-stage

STUART CH4-40 FL pumps are optimal for water pressurisation to outlets in a positive head application, where an instant boosted supply is required from a simple to install package. CH Automatic Flow Switch pumps require a gravity flow of 1 litre/minute to operate and are suitable for commercial or domestic use, pumping hot or cold water at flow rates up to 141 litres per minute and heads up to 36 metres.

Centrifugal Horizontal Unit multi-stage

STUART CH 4-50 FL pumps are optimal for water pressurisation to outlets in a positive head application, where an instant boosted supply is required from a simple to install package. CH Automatic Flow Switch pumps require a gravity flow of 1 litre/minute to operate and are suitable for commercial or domestic use, pumping hot or cold water at flow rates up to 145 litres per minute and heads up to 50 metres.

Centrifugal Horizontal Unit multi-stage

STUART CH4-60 FL pumps are optimal for water pressurisation to outlets in a positive head application, where an instant boosted supply is required from a simple to install package. CH Automatic Flow Switch pumps require a gravity flow of 1 litre/minute to operate and are suitable for commercial or domestic use, pumping hot or cold water at flow rates up to 148 litres per minute and heads up to 62 metres.

Replacement reed switch suitable for all Monsoon Standard and Monsoon Universal pumps manufactured after 2008.

Contents:

• Reed Switch x1
• Strain Relief Bush x1
• Tie Wrap x1
• Screw Self Tapping 3.5mmx12mm x4
• Screw Self Tapping K40x16mm x4

Stuart Turner (est. 1906) is a UK manufacturer of water boosting and pressurisation systems. Their ranges include shower pumps, whole-house boosting sets and mains-pressure solutions. Typical applications are improving water pressure and flow in homes and light commercial buildings.

Spare Part

Replacement pressurisation vessel, appropriate for all Monsoon Universal pumps manufactured after 2008.

Contents:

• Pressure Vessel 0.6 Litre (x1)
• Rubber Washer 1/2" BSP (x1)
• O-Ring (x1)

Unit Management Module

The Management Module remotely switches pumps without controls and can be utilised in both positive and negative head plumbing systems.
The pump incorporates a pressure switch to start a connected pump and a flow switch to stop the pump, ensuring a continuous supply of boosted water to all outlets without hunting. Incorporating pump run dry protection, the control module features a simple LED display for power on, pump running and fault indication.
The pump is supplied with a 70 mm long extension piece allowing the module to clear the pump terminal box.