-
MP63C 330
Sacemi - MP63C Coolant Pump - 330mmUsual installation is onto a tank with a capacity proportionate to the flow rate, about 4-5 cm from the bottom. This product is manufactured by Sacemi. It is important to check that the maximum level of liquid in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is recommended to build the tank with compartments, to allow the deposit of sludge before it is fished out by the pump. For different uses it is advisable to consult our Technical Department.
The Sacemi MP63C Coolant Pump - 330mm is a Coolant Pump item.
£544.80 £454.00
In stock
Free Standard Delivery
-
IMM80B-300-3
Sacemi - IMM80B Coolant Pump - 415V - 3 Phase - 300mmUsual installation is onto a tank with a capacity proportionate to the flow rate, about 4-5 cm from the bottom. This product is manufactured by Sacemi. It is important to check that the maximum level of liquid in the tank always remains 3-4 cm lower than the support flange (see figure). In cases where the liquid is particularly dirty, it is recommended to build the tank with compartments, to allow the deposit of sludge before it is fished out by the pump. For different uses it is advisable to consult our Technical Department.
The Sacemi IMM80B Coolant Pump - 415v - 3 Phase - 300mm is a Coolant Pump item. Voltage for this item is 415V.
£1,024.80 £854.00
In stock
Free Standard Delivery
-
AU63-1/2-3
Sacemi - AU63-1/2-3 Gamar Tank Mounted Pump - 13 Ltr/minThey are appropriate for the transfer of clean liquids, containing impurities not exceeding 0.03 mm. This product is manufactured by Sacemi. The hydraulic components: brass impeller, Cast Iron bottom and aluminum pump body, allow it to be applied with emulsions, oily substances and liquids in general as long as they are not oxidizing for the construction materials. The viscosity must not exceed 21 cSt (3 ° Engel).
Applications
They must be installed on the top of the tank and must be primed before use. In cases where the pump sucks in air due to lack of liquid, the priming operation must be repeated. To ensure a correct life of the pump, it must not be run dry, as the mechanical seal is not lubricated. Where possible, the installation of a suction filter is recommended. For other uses, we recommend that you consult our Technical Department.
The Sacemi AU63-1/2-3 Gamar Tank Mounted Pump - 13 Ltr/min. is a Tank Mounted Pump item. It has an actual flow rate of 13 Ltr/min. This is a Surface Mounted pump which can be suitable when the pump can sit in a dry, accessible location and draw liquid in via a suction pipe or hose.
£530.40 £442.00
In stock
Free Standard Delivery
Sacemi
(12168 products)